M2 — FREQUENCY SECTIONS, SPARE AND TONAL BALANCE RECORD
Date / event / room / responsible technician:
M2 cabinet / identification / connector / quantity:
Main and spare amplifier / firmware:
Channel pair / input / 2-Way Active mode / M2 setup:
Physical output / panel / adapters / cables:
LF: positive and negative contacts / continuity / crossed conductors:
HF: positive and negative contacts / continuity / crossed conductors:
SenseDrive EP5 / five conductors / OUT A / local link, if applicable:
NL8 SenseDrive: manufacturer confirmation and applicable configuration:
Initial state: mute / level / EQ / delay / CUT / CPL:
Agreed test signal and level / protection and area access:
Each cabinet alone / pair / performer's working positions:
Single change / observed result / next step:
Missing HF: cable swap / cabinet swap / output kept unchanged:
Microphone and mix, if feedback occurs:
Subwoofer and processing, if comparing CUT:
Spare test / settings compared / both frequency sections:
Final state / responsible technician / removed equipment / open issues:

Blank worksheet; it does not certify GLMedia tests or results.
Continuity: amplifier off, cable disconnected at both ends.
Do not connect drivers to full-range outputs. This worksheet does not validate rigging.