T10 — HORN POSITION, SETUP AND WIRING RECORD
Blank worksheet. It contains no GLMedia test results.
Reference: d&b T10 Manual 1.1 en, June 2023, pp.4–9.

Event / venue / date:
Person responsible:
Each T10 ID / cabinet count / destination:
Role: single cabinet, frontfill or array section:
Cabinet orientation and horn/lens position:
Exact mounting hardware and accessories / manual checked:
Amplifier / firmware / setup / Output mode:
T10 count per channel / grouping:
Connectors, adapters and wiring map:
Exact subwoofer and signal path, if used:
Starting configuration: CUT / HFA / HFC / CPL / level / delay:

AGREED TEST
Test signal and level:
Listening positions and transition areas:
Proposed comparison / single adjustment / reason:
Observed result, to be entered after the test:
Fault found / output, cable, cabinet or area affected:
Restored configuration / next action:

Record the physical horn position separately from the amplifier setup.
This record does not validate mounting hardware, an array, subwoofer alignment or an ArrayProcessing configuration.
Check continuity only with the amplifier switched off and the cable disconnected at both ends.