GLMedia · D12 · CAN control and detection in R1
Blank fields for actual checks; no prefilled results.

Event / venue / date / system technician: ________________________________________
Rack / amplifiers / firmware / R1 version: ________________________________________
Identified interface / model / power: ________________________________________
Saved project / configuration reference / date: ________________________________________
Computer side / USB or Ethernet / IP and subnet where applicable: ________________________________________
CAN path / physical amplifier order / attached map: ________________________________________
dbCAN-ID per node / duplicate IDs / previous assignment: ________________________________________
Bus end / terminator / interface position / TERMINATE: ________________________________________
Section cable / length / shield / connectors / check: ________________________________________
Detected devices / first missing device: ________________________________________
If using R70: ON / LAN / CAN / ERR / time / exact state: ________________________________________
Isolated section / new terminations / cable used / test window: ________________________________________
Proposed change / reason / devices before and after / actual result: ________________________________________
Restored path and configuration / pending issue / next action: ________________________________________

Change cabling during a test window. Check both ends when shortening the bus. Turn off the amplifier before touching power-output connections. Do not factory RESET without preserving configuration.
D12 Hardware 4.9 EN, 02/2014: §5.1.3. TI 312 1.5 en, 05/2021: §§4,6,8,10,12,15. R70 Hardware 1.4 EN, 04/2009: §2.2.1–2.2.2.