CHAUVET NET-X II — UNIVERSES, DMX OUTPUT AND SOURCE LOSS
Blank worksheet: fill in during the actual test.

Date / event / room / operator:
Node ID / Firmware Version:
Console and software version / fixture and mode:
Protocol / IP address / netmask / switch and cable route:
Physical port / DMX Status / DMX Mode / Protocol:
Disp Type (DEC/HEX) / Network / 1st Universe:
Console output line / transmitted network universe / destination:
Signal mark / I-O-x indication / measured values:
Known-good cable and fixture / comparison port:
On Source Loss / NetWork Timeout (when merging):
Test look / transmission stopped at / fixture response:
Transmission resumed at / recovery / intervention needed:
Initial setting / one change / result / next check:
Configuration backup / recorded scenes preserved by another method:
Spare path / final configuration / authorized for show by / unresolved issues:

The menu Backup function excludes recorded scenes. Factory Reset deletes recorded scenes. Preserve the information needed to rebuild them before resetting.
Do not connect a network when using the DMX splitter presets. Do not open the node. Stopping DMX transmission is not the same command as sending zeros; test the fixture's signal-loss behavior.
This blank worksheet records your test, not a test already performed by GLMedia.