onAir Panel 1 IP — DMX, CCT, PWM AND SIGNAL LOSS
Date / event / room / technician:
Actual model / unit / Disp Ver / Drv Ver / Net Ver:
Console / software / fixture profile / DMX Channel personality:
Protocol / DMX Address or Ethernet Universe-Start Channel:
Input path / NET-X II or other node / downstream fixtures:
Dimmer / Fine dimmer / CCT DMX value and nominal Kelvin / Hue:
Strobe / Effect Macros / Red Shift / initial state:
Camera / model / mode / fps / shutter / exposure / WB:
Initial LED Frequency / dimmer level / other sources isolated:
Single PWM change / identified clip / observed bands:
Comparison at other levels / fades / other modes / result:
DMX Loss on panel / source-node / downstream fixtures:
Ethernet To DMX / Wireless To DMX if used in the signal path:
Agreed cue / loss at source or final cable segment:
Panel light / output to other fixtures / observed response:
Data restored / cue recovered / intervention:
Final state / saved settings / contingency / remaining checks:

Blank worksheet. This does not document tests or measurements by GLMedia.
Ranges: manual Rev.4 03/2024; check actual firmware and patch.
Stop DMX holds the panel's light; it is not equivalent to Blackout.
Do not interrupt the signal during the live program to perform this test.