HOLLYLAND PYRO S — FORMAT, LINK AND BACKUP
Date / event / person responsible:
TX / RX / label / H100-H110 revision / firmware on each unit:
Actual kit quantity and composition / accessories:
Exact camera / firmware / manual / recording format:
Camera output / HDMI-SDI / resolution / p-i-PsF / rate:
Camera-TX cable / TX Resolution & Frame Rate reading:
Group / broadcast-unicast mode / connected devices:
Antennas / position / route / observed obstructions:
DC-NP-F supply / model / ratings / battery / stability:
RX reading / connection status / output format:
RX-destination cable / HDMI-SDI / destination model / accepted format:
Direct cable: observed picture, motion and audio:
HD-Smooth Scene Mode / detail / delay / test method:
Frequency Scan / channel / AUTO / before-and-after status:
Frozen Frame / observed interruption / motion reference:
Original settings / single change / result / repeat:
Prepared backup / switch to destination / return to program:
Restored settings / equipment removed / support / outstanding issues:

Blank test record. Complete with results from this setup.
Guide V1.0.0: printed p.18/PDF p.20 for formats; printed pp.11–14/PDF pp.13–16 for controls.
Identify firmware and hardware revision; do not update during the event.
USB-C cannot power Pyro S. Use an identified, compatible supply.
A retained frame does not prove reception of moving video.
A channel change can interrupt video. Test the backup and return during rehearsal.