COLORADO BATTEN Q15 — CELL CONTROL AND FILTER TEST
Date / event / technician / unit ID:
Information-Firmware Version / UID:
Console / version / fixture library / profile:
Personality / Start Address / universe / output / reserved range:
Master-Slave / Static-Auto / test cable:
Channel / value sent / color / observed cell:
Dimmer / Fine / Macro / Temperature / Strobe:
Cell Order / physical end / observed sequence:
Exact filter / glare shield / lens condition:
Height / drape distance / tilt / approved mounting:
Color / level / camera and audience positions:
Center / ends / overlaps / spill outside the drape:
Initial setup / single change / result / repeat test:
Fallback / restored configuration / unresolved issues:

Complete this worksheet during the fixture test.
Manual Rev. 4 (June 2026), DMX Chart Rev. 1 and Photometrics Report.
Do not set every channel to 255: strobe or macros may activate.
Do not feed console DMX into a chain operating in Master/Slave mode.
Disconnect power and allow cooling before handling the filter or shield.
Maintain the manual's 50 cm clearance from adjacent surfaces and flammable materials.
Check supports; bolt the floor base plate to a stable surface.
Do not open the fixture; contact support for damage or serious faults.