GLMedia — Proposed worksheet: MADI paths and expected signal
Enter measured values and listening results after each test; mark untested paths as pending.
Event / date / operators / observer / test window / agreed level:
Manufacturer / console model / software / rack / firmware / cards:
Applicable manual / edition / section / link:
Initial file and screenshots / person responsible for recovery:

PATHS
Sender | connector label | identified cable | receiver and connector | required function
______ | _________________ | _________________ | ____________________ | _________________
Sample rate and format read at sender / receiver / required channel:
Expected signal: input / FOH mix / monitor send / other:
Dependencies on another position / agreed operational authorization / return:

PROPOSED CHANNEL CHECK
Source channel | received channel | meter | listening and destination | duration | result
___________ | _____________ | _______ | _________________ | ________ | _________
Proposed selection: 1, 28, 29, 56; then complete those required for the event.
Unchecked channels / reason / person responsible:

IDENTIFY THE SIGNAL
Source used / expected origin / listening destination:
Initial setting | single changed condition | subsequent values | listening | return
_____________ | _______________________ | __________________ | _______ | _______
Observed result / pending hypothesis / preserved evidence:
Alternative to verify / missing models and manuals / next step:

HANDOVER
Path | result | pending | person responsible | screenshot before/after
_________ | _________ | _________ | ___________ | _____________________
Status: proposed / performed / repeat pending / support pending
References: DiGiCo SD Rack manual B August 2013, pp.1-5, 1-7, 1-12, 1-13; TN294 rev. 3, 27/02/2013, pp.1–3.
Do not extrapolate SD port numbering to Quantum or SD Rack documentation to SD Mini.