Lighting and control
DMX cable — 100 ft
Prepare each section of the DMX route with the cable and connectors identified. The record lists 100 ft; confirm the cable assembly reference and how it will connect to the equipment before finalizing the run.
Identification and scope
- Manufacturer or brand
- Check the identification on the unit
- Equipment name
- DMX cable — 100 ft; part number to confirm
- Location
- Ask about availability and location
- Reference quantity or measurement
- 6 (record reference quantity; confirm units for the event)
You can ask with the equipment you need to connect, the date and location even while the route is still approximate. We’ll review lengths, connectors and supply options.
Information to prepare this item
- Cable part number, length, connectors at both ends, identification and observed condition.
- Source and destination of the section, complete DMX route, intermediate equipment and termination according to the system documentation.
Confirm the ends and route
Record the assembly’s brand or code and legible photos of its labels and connectors. The name DMX alone does not identify the contact count, pinout or adapters the link may need.
Place the 100 ft section within the complete route, including equipment and pass-through points. Check lengths and cable protection; the recorded quantity does not confirm units available for a date.
Prepare the link and its check
| Point | What to record | How to proceed |
|---|---|---|
| Cable and connectors | Part number, ends, length and observed condition | Confirm connections and accessories against the cable assembly and equipment documentation |
| Complete route | Controller, equipment, intermediate sections and end of the link | Review the layout and termination for the documented system |
| Check | Symptom, affected section and test conditions | Check one change at a time and record the result before event use |
For intermittent faults, record where they appear and first check the identified section and its connections. To isolate the cause, follow the system procedure and compare with a suitable cable that has already been verified; also keep a record of the patch and equipment used.
Documentation for finalizing the configuration
Once the cable part number and equipment models are known, we can check the applicable data sheet and connection layout. This page does not assign a pinout, impedance, connector type or maximum reach based on the record name.
Topics to discuss
- Cable identification
- Route and connections
- Link termination
- Signal check
Confirm the cable part number and documented equipment connections before using adapters or changing terminations.
Continue the inquiry
- Event lighting: faces, audiences and scenes that work
- Fixture profile and DMX mode: check the patch before programming
- LED fixtures flicker with DMX: what to check and how to test
These guides cover related tasks. Check the model each guide addresses before applying its settings to this equipment.