Rigging and power
CS1-RS2 — 2 mm R-clip
Plan retention as part of the complete connection. The Eurotruss catalog identifies CS1-RS2 as a 2 mm R-clip; the proposed clip, pin, connector and configuration must be checked against the system documentation.
Identification and scope
- Manufacturer or brand
- Eurotruss (catalog reference; piece to verify)
- Equipment name
- CS1-RS2 — 2 mm R-clip
- Location
- Ask about availability and location
- Supply for the event
- Ask about options for the planned date and scope
You can start with the assembly you want to build, the date and the location even if you do not yet have a final drawing. We will review the component references and supply options.
Information to prepare this item
- Component identification, nameplate and documentation; actual assembly configuration.
- Assembly geometry, planned loads, supports and connections, reviewed by the qualified person responsible.
Confirm the piece and the connection it belongs to
Record the intended retainer, pin and connector references, together with the identification of the truss system. Check the components against the applicable manual and drawings; the clip’s shape or size alone does not prove compatibility.
Keep each component’s identification and check that the assembly list includes every piece required by its documentation. Do not substitute a retainer based only on its appearance.
Prepare the assembly review before installation
| Point | What to record | How to proceed |
|---|---|---|
| Identification | Intended retainer, pin, connector and system | Confirm references against the connection documentation |
| Configuration | Geometry, loads and positions, supports and connections | Request a review by the qualified person responsible for that assembly |
| Condition and components | Required pieces and the observed condition of each component | Resolve missing pieces or discrepancies before adding the components to the assembly |
If a piece is missing, its identification is uncertain or its observed condition differs from what was expected, record the discrepancy and arrange its assessment or replacement before use. Visual inspection does not replace documentation or a review of the configuration.
Manufacturer reference and connection documentation
Eurotruss: connector and connection component catalog
The official page lists CS1-RS2 as a 2 mm R-clip. That reference does not confirm the piece in this record or what a proposal includes. Once the system has been identified, we can gather the specific assembly and inspection instructions.
Topics to discuss
- Component identification
- Configuration and documentation
- Assembly coordination
- Inspection and recordkeeping
Before applying settings, identify the complete equipment variant and consult its documentation.
Continue the inquiry
- What to coordinate with the hotel or venue before AV setup
- Event stages: choosing size, height and access
These guides cover related tasks. Check the model each guide addresses before applying its settings to this equipment.